Study with 350-080 most valid questions & verified answers

Refer to the exhibit.

The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B (Path C).
Which actions might be used to change this behavior?

• A. Fix the port channel configuration between Fabric Interconnect B and Nexus 5548 B as the port channel IDs do not match.
• B. Modify the bridge priority on the Nexus 5548s so that one of them will always be the root bridge.
• C. Modify the bridge priority on the fabric interconnects so that one of the Nexus 5548s will always be the root bridge.
• D. Modify the port priorities on the fabric interconnect uplinks (Paths B and C) so that they are a higher priority than ports Eth1/4 and Eth1/9 (Path D).
• E. This is an invalid configuration as Cisco UCS fabric interconnects cannot be directly connected.

n1kv-l3(config)# show lacp offload status Current Status : Enabled Running Config Status : Enabled Saved Config Status : Disabled
What two facts does the output signify? (Choose two.)

• A. LACP is enabled on the Nexus 1000v.
• B. LACP will be offloaded to the upstream switch.
• C. LACP is negotiated by the VEM in all instances.
• D. LACP will be negotiated to the VM.
• E. LACP is negotiated by the VSM.

Which statement describes OTV configuration on the Cisco Nexus 7000 Series Switches?

• A. OTV uses an SSM group range for neighbor discovery and to exchange MAC reachability with other OTV edge peers.
• B. The OTV join interface is a routed uplink interface on the edge device used to physically join the overlay network.
• C. The OTV control-plane protocol uses the IS-IS protocol to establish adjacencies and exchange MAC reachability across the overlay network. You must enable IS-IS with the feature isis command before OTV adjacencies can be established.
• D. The OTV internal interface encapsulates the site Layer 2 frames in IP unicast or multicast packets that are then sent to the other sites.

The network administrator is adding a new N1Kv to the vCenter, however, the administrator does not see the new switch under the networking tab of vCenter.
The administrator issues the following command on the VSM to troubleshoot:
VSM# show svs connections connection VC: ip address: 10.10.10.30 remote port: 80 protocol: vmware-vim https certificatE. default datacenter namE. DC1 DVS uuiD. 67 32 30 50 a6 d2 49 64-9e 1c 5f 49 e3 af 55 99 config status: Disabled operational status: Disconnected sync status: version:
When attempting to fix the issue, the following error is seen:
VSM-PRI-188# conf VSM-PRI-188(config)# svs connection VC VSM-PRI-188(config-svs-conn)# connect ERROR: [VMWARE-VIM] Extension key was not registered before its use
What is the cause of the error?

• A. Missing packet VLAN in VSM configuration
• B. VSM has no network connection to vCenter
• C. VSM extension key is not installed on vCenter
• D. vCenter extension key is not installed on VSM
• E. Missing control VLAN in VSM configuration

Which option lists valid network interfaces for VSM?

• A. Layer 2, Layer 3, and keepalive
• B. management, Layer 2, and Layer 3
• C. control, management, and packet
• D. management, packet, and VSM