Assume EMC DES-1221 Dumps PDF Are going to be The Best Score
DCS-IE DES-1221 Exam and Certification Test Engine
NEW QUESTION 16
A storage administrator has provisioned 10*2GB volumes. 400MB of data is written to each of the ten volumes. What is the Thin Savings ratio for this configuration?
- A. 4:1
- B. 3:1
- C. 6:1
- D. 5:1
Answer: C
NEW QUESTION 17
A protection policy with snapshot and replication rules is applied to a file system. What is the result?
- A. Replication rules get ignored and only snapshot rules get applied
- B. Applying the protection policy to the file system fails
- C. Snapshot rules get ignored and only replication rules get applied
- D. Both replication and snapshot rules get applied
Answer: D
Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/data-protection-in- powerstore?guid=guid-19c6d0e1-fa20-4fb5-9983-61c17abaf21b&lang=en-us
NEW QUESTION 18
An administrator received a request to provision a new volume. Use the simulator to provision a volume of 50 GB with a performance policy of high for their host named "ApplicationTeam". When you have finished using the simulator, click Next.
Answer:
Explanation:
Below are the exhibits solution for this simulation.
NEW QUESTION 19
Which type of network is used for storage migration between appliances?
- A. Intra-Cluster Data network
- B. Intra-Cluster Management network
- C. Storage network
- D. Inter-node network
Answer: A
NEW QUESTION 20
Match the correct Base Enclosure port in column A to the Expansion Enclosure port in column B to show the correct cabling for adding a single expansion enclosure to a base enclosure.
Answer:
Explanation:
Reference:
https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-isg/cable-the-base-enclosure-to-the- expansion-enclosure?guid=guid-d68d049f-2b77-489f-b1ab-553f4f3de8aa&lang=en-us
NEW QUESTION 21
Correctly arrange the sequence of the write operation in PowerStore.
Answer:
Explanation:
NEW QUESTION 22
What does the remote replication Failover operation do?
- A. Fully synchronizes the source and destination data states and reverses the replication direction
- B. Fully synchronizes the source and destination data states and stops the current replication session
- C. Promotes the destination system to production with its replica data consistent to the last successful RPO synchronization state
- D. Promotes the destination system to production and resets the RPO synchronization cycle in the protection policy
Answer: D
NEW QUESTION 23
What is the recommended Windows multi-pathing policy for block volumes on a PowerStore array?
- A. Round-Robin
- B. FailOver
- C. Least QueueDepth
- D. Least Weighted Paths
Answer: A
NEW QUESTION 24
A storage administrator has provisioned a 50GB volume and presented it to an application. The application owner has requested that the volume be replicated to a secondary array. Which policy should be assigned to the volume to enable replication?
- A. Replication
- B. Performance
- C. Protection
- D. Remote
Answer: C
NEW QUESTION 25
What is the significance of the warning given when a volume with data services is deleted?
- A. Volume is participating in a migration
- B. Volume is mapped to a host
- C. Protection policy is configured on the volume
- D. Snapshot is present on the volume
Answer: D
Explanation:
Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-cfg-vols/delete-a-volume?
guid=guid-26e8c12d-a3df-4d4d-8012-ae2ef9e53721&lang=en-us
NEW QUESTION 26
An administrator is trying to set a performance policy while creating a Thin Clone of a volume group. Why is the option to set performance policy unavailable?
- A. No Volumes are added in the volume group
- B. Volumes in the volume group are not mapped to any hosts
- C. Performance policy can only be set on a Thin Clone volume
- D. Thin Clones cannot be created using a volume group
Answer: C
Explanation:
Reference:
https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-cfg-vols/remove-a-volume-from-a- volume-group?guid=guid-4b974223-26e4-40fe-a1b8-01beb210c305&lang=en-us
NEW QUESTION 27
An administrator receives an alert on a PowerStore Cluster with three appliances:
The appliance A1 is projected to run out of space in 8 days
Capacity utilization is above 90 percent
Which tools are available to assist the Administrator with a potential resolution?
- A. System Optimization
- B. Thin provision conversion wizard
- C. Space reclamation wizard
- D. Assisted Migration
Answer: D
Explanation:
Explanation/Reference:
Reference: https://volumes.blog/2020/05/18/what-is-powerstore-part-11-resource-balancer/
NEW QUESTION 28
A protection policy with snapshot and replication rules is applied to a file system. What is the result?
- A. Both replication and snapshot rules get applied
- B. Applying the protection policy to the file system fails
- C. Snapshot rules get ignored and only replication rules get applied
- D. Replication rules get ignored and only snapshot rules get applied
Answer: D
Explanation:
Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/data-protection-in- powerstore?guid=guid-19c6d0e1-fa20-4fb5-9983-61c17abaf21b&lang=en-us
NEW QUESTION 29
A storage administrator has provisioned 10 * 2GB volumes. 400MB of data is written to each of the ten volumes. What is the Thin Savings ratio for this configuration?
- A. 4:1
- B. 3:1
- C. 6:1
- D. 5:1
Answer: D
NEW QUESTION 30
Refer to the Exhibit.
Which port location in the graphic is used for network management connectivity on a PowerStore T?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 31
Use the PowerStore Manager simulator to configure the BaseEnclosure-NodeA-IoModule1-FEport0 as a replication port. When you have finished using the simulator, Click Next.
Answer:
Explanation:
check the answer below in explanation.
Explanation
Below are the exhibits solution for this simulation.
NEW QUESTION 32
In a PowerStore T source cluster, create a 100GB volume with name "Prod_vol" and set a protection policy to replicate the volume with RPO 30 minutes to a destination cluster. The destination cluster is already configured. When you have finished using the simulator, click Next.
Answer:
Explanation:
check the answer below in explanation.
Explanation
Below are the exhibits solution for this simulation.
NEW QUESTION 33
A Storage Administrator removed an appliance from the cluster. What is the status of the removed appliance's licenses?
- A. Licenses becomes void
- B. Licenses are erased
- C. No licensing impact
- D. New licenses are created
Answer: B
NEW QUESTION 34
An administrator assigns a protection policy to a volume group. Volume1, Volume2, Volume3 are put into the volume group. Later it is decided that Volume2 should be replicated at a different time. Volume2 is removed from the volume group. The administrator attempts to assign a new protection policy to Volume2 and the option is greyed out.
Why is the option greyed out?
- A. Still has associated Volume-Group snapshots
- B. Requires a snapshot rule and a replication rule
- C. Requires a replication rule not a protection policy
- D. Already has a protection policy from the Volume-Group
Answer: D
NEW QUESTION 35
Match the correct Base Enclosure port in column A to the Expansion Enclosure port in column B to show the correct cabling for adding a single expansion enclosure to a base enclosure.
Answer:
Explanation:
Reference:
https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-isg/cable-the-base-enclosure-to-the-expansion-enclosure?guid=guid-d68d049f-2b77-489f-b1ab-553f4f3de8aa&lang=en-us
NEW QUESTION 36
An administrator received the following alert from PowerStore regarding a previously created NAS server?
Description:
The SMB server of the NAS server PowerStore_NAS_01 is configured to be joined to the domain test.mid, but is currently not joined.
Which setting should the administrator change?
- A. UDS
- B. NTP
- C. LDAP
- D. SMB
Answer: D
Explanation:
Explanation/Reference: https://www.dell.com/support/article/en-pk/sln317202/powerstore-alerts-smb-server-alerts?
lang=en
NEW QUESTION 37
A VM administrator uses their PowerStore user account and noticed they are unable to change their password. Why?
- A. Validate user in Active Directory not set
- B. VM Administrator role cannot set password
- C. Extended schema for Unix users in Active Directory not set
- D. In settings > users: enable allow user to change password not set
Answer: D
NEW QUESTION 38
A storage administrator has provisioned a 50GB volume and presented it to an application. The application owner has requested that the volume be replicated to a secondary array. Which policy should be assigned to the volume to enable replication?
- A. Protection
- B. Performance
- C. Replication
- D. Remote
Answer: C
NEW QUESTION 39
Refer to the Exhibit.
Note the yellow arrow. A Data Center Engineer notices that the LED is blinking blue and amber alternating at one second intervals. What does this indicate?
- A. System is booting
- B. Node in Service Mode
- C. Node is Degraded
- D. System not initialized
Answer: B
NEW QUESTION 40
What is the significance of the warning given when a volume with data services is deleted?
- A. Snapshot is present on the volume
- B. Volume is mapped to a host
- C. Volume is participating in a migration
- D. Protection policy is configured on the volume
Answer: C
NEW QUESTION 41
......
Difficulty in Attempting Specialist â Implementation Engineer, PowerStore Solutions Version 1.0
Easy4Engine provide DELL DES-1221 practice exams and DELL DES-1221 practice test which makes goal of passing DELL DES-4421 exam more achievable for exam aspirants. Easy4Engine provides relevant and constantly updated dumps.Easy4Engine dumps are verified by the DELL experts. Easy4Engine also gives practice test, which proves to be an excellent platform to test the attained knowledge.
Use DES-1221 Exam Dumps (2021 PDF Dumps) To Have Reliable DES-1221 Test Engine: https://www.easy4engine.com/DES-1221-test-engine.html
DES-1221 PDF Recently Updated Questions Dumps to Improve Exam Score: https://drive.google.com/open?id=1A13El78Qb59ynG5SAg1-63ZKHnEebeWp
