HP HPE6-A66 Practice Verified Answers - Pass Your Exams For Sure! [2021]
Valid Way To Pass HP Certification's HPE6-A66 Exam
NEW QUESTION 26
A network architect needs to plan a new wireless network
- A. Airwave and Central only
- B. Central only
- C. Airwave, Central, Windows, Mac OSX, and Linux
- D. Airwave, Central, and Windows only
Answer: A
NEW QUESTION 27
Which AP mode allows an AP to operate autonomously?
- A. AM
- B. IAP
- C. RAP
- D. OCAP
Answer: D
NEW QUESTION 28
A wiring closet with a POE+ switch is 250 feet (76 meters) away from an AP on a building floor. The AP's smart-rate port is connected to a smart-rate port on the switch, which is capable of 10 Gbps. The cable type is Cat5e STP. What is the maximum speed that the customer can expect from the connected AP?
- A. 5 Gbps
- B. 1 Gbps
- C. 10 Gbps
- D. 2.5 Gbps
Answer: D
NEW QUESTION 29
Which feature does the Aruba AP 555 support? (Select two.)
- A. 802.11ac and lower standards only
- B. three radios
- C. desk wall plate mounted
- D. high density indoor locations
- E. weather proof and temperature hardened
Answer: A,D
NEW QUESTION 30
A network architect is redesigning a wireless network. The architect begins by analyzing the number of spatial streams supported by APs of various vendors as well as the wireless devices currently in the network, if the company wants to ensure that new wireless design, including user wireless devices, support Multi-User MIMO (MU-MIMO). which standard or standards must the wireless products support?
- A. Only 802.11ax
- B. Only 802.11ax,802.1lac, and 802.l1n
- C. Only 802.11ax and 8011.ac
- D. Only 802.11ax,802.11ac, 802.11n, and 802.11a
Answer: B
NEW QUESTION 31
Which component uniquely defines the BSSID when implementing an employee SSID?
- A. Case-insensitive SSID name
- B. Wireless device MAC address
- C. Radio MAC address
- D. Case-sensitive SSID name
Answer: B
NEW QUESTION 32
A customer has some employees that travel to various locations, where these employees will need Wi-Fi access at these locations. Because many of these locations do not have wireless support, the employees will need to carry an AP solution with them. Internet connectivity, if it doesn't exist at these locations, will be provided by a national phone company USB wireless card which will be connected to AP. The wireless solution needs minimal bandwidth, but needs to minimally support 802.1 lac wave 1 devices.
Which Aruba AP wireless solution would meet the needs of these employees most effectively and cost efficiently?
- A. 0
- B. 203R
- C. 1
- D. 303H
Answer: B
NEW QUESTION 33
A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall-mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?
- A. Paint the APs to match the ceilings or walls
- B. Place a strip of tape over the LEDs
- C. Order Aruba AP covers for the APs
- D. Place the APs above the ceiling and behind the walls
Answer: D
NEW QUESTION 34
When a WLAN has to support nomadic devices, a network architect must primarily plan for which component in their design?
- A. number of users per location
- B. mobility requirements and usage
- C. type of users
- D. density of users
Answer: B
NEW QUESTION 35
When determining a customer's agenda and clarifying their expectations for a new HPE/Aruba deployment, which two questions should be asked during the stakeholder checklist? (Select two.)
- A. What is the networking experience of onsite personnel?
- B. What business problems are you trying to solve?
- C. Which help desk system is deployed?
- D. What is your anticipated growth of the environment?
- E. is a request for proposal or actual bill of materials (BOM) required?
Answer: B,E
NEW QUESTION 36
A network architect is creating a new wireless solution for a customer. Wireless coverage is required throughout all four floors of two buildings on the same campus. Dynamic RF capabilities, including AirMatch, are required. Seamless roaming is required within and between the two buildings. Each floor will have approximately 20 APs and 6 external APs are required for connectivity between the two buildings.
- A. A standalone 7008 controller per floor
- B. Two 7205 mobility controllers in a cluster
- C. Given this information, which Aruba solution would be the most cost-effective while still meeting the customer's requirements? O An IAP cluster per floor
- D. Two 7030 mobility controllers in a cluster
Answer: C
NEW QUESTION 37
A customer currently has sets of three Aruba 5406R switches deployed for an access layer in multiple wiring closets in a building They are clustered in a VSF domain The customer wants to set up Multiple Active Detection (MAD) for the OOBM port, as well as use this port for remote management access. To simplify the connectivity, the customer wants to connect these three switches' OOBM ports to a separate switch in the wiring closet for the OOBM connectivity.
Which would be the most cost-effective solution that would meet the customer's requirements?
- A. 2930M
- B. 0
- C. 2930F
- D. 5406R
Answer: B
NEW QUESTION 38
A network architect is doing a site survey for a new wireless design One concern the company has with the old wireless network is coverage. In some cases, APs would lose power and some employees in the network would lose wireless connectivity. The new design needs to prevent this issue from occurring. During the site survey, what are best practices to be followed in regards to the dBm signal level and the power of the AP to ensure adequate wireless coverage and minimal overlap of AP signals for the new design?
- A. AP power at 50% and a measurement of -65 dBM on the measuring device
- B. AP power at 75% and a measurement of -90 dBM on the measuring device
- C. AP power at 75% and a measurement of -80 dBM on the measuring device
- D. AP power at 100% and a measurement of -65 dBM on the measuring device
Answer: D
NEW QUESTION 39
A company is redesigning their wireless network and will be upgrading all devices to support the latest wireless standards. The company is not near any radar installations. In order to keep wireless NIC power levels as low as possible to reduce interference issues and to take advantage of radar frequency ranges, what IEEE standard should APs support?
- A. S02.11h
- B. S02.11V
- C. 802.11 ax
- D. 802.11r
Answer: C
NEW QUESTION 40
A company is installing Internet of Things (loT) devices to support a smart and energy-efficient environment for a building, including loT devices for heating and air conditioning, lights, and window shades. loT devices of these types are typically classified as which category of devices?
- A. Nomadic devices
- B. Stationary devices
- C. Somewhat mobile devices (SMD)
- D. Highly mobile devices (HMD)
Answer: A
NEW QUESTION 41
A network architect is designing a wireless solution for a company that is leasing one floor in a multi-floor building in a downtown area. The customer is concerned about ensuring complete Wi-Fi coverage and pin-pointing RF hazards. What type of survey should the network architect perform?
- A. Active
- B. Virtual
- C. Spectrum clearing
- D. Passive
Answer: A
NEW QUESTION 42
......
HP HPE6-A66 Pre-Exam Practice Tests | Easy4Engine: https://www.easy4engine.com/HPE6-A66-test-engine.html
HPE6-A66 practice test questions, answers, explanations: https://drive.google.com/open?id=1zElMGfFjxqIfCpsJDj720fEVfGSknbDf
